DEM data for QMapShack. How to add it

DEM data for QMapShack. Adding it to the QMapShack program.
I have been using QMapSahck for about a year now. I am running Arch Linux.

I QMapShack for modifying GPX traces that I download for my Treks. Often these traces are not very well recorded or need modifying or cleaning up.

Very Linux (in other words very often not very clear to use) QMapShack is extremely powerful but can be difficult to understand. The problem is that I have only found one forum for it in German. I do not speak or understand a word of Germain and as there are no real explications of how it works. It can be a little trying.

I was modifying a trace that I had downloaded for an upcoming trek in 2021 but every time I edited some track points I lost the elevation details and the small track info windows would become empty

Good elevation info thanks to DEM data
Good elevation info thanks to DEM data
Lost elevation data. No DEM data

After quite a while. I finally realised that this was due to QMapShack not having the elevation info, and also realised that I would need to get this from somewhere using DEM files

So how to use DEM files

Firstly in your QMapShack folder. Mine is in /home/trevor/qmapshack

I have or created (I can’t remember which) a DEM folder

I then open from where you can download the DEM tiles for the area that you need. In my case France, so loads of tiles and you have to download them one at a time, doh .

One tile to download at a time.

Now I download these tiles to a folder that I had created in my DEM folder. I called it franceDM (you will need to dezip them later or extract them while downloading)

my folder and VRT file in my DEM folder

You will have as shown in the image above a file N48E001

When all tiles downloaded you will probably have many
So you’ve downloaded the tiles

I assume that you have downloaded all the tiles that you need, again in my case all that covers France

Now in the program QMapShack

Firstly add a window from the top tool bar : Window – – Dig. Elev. Model (DEM) see further below

Then from the top tool bar : Tool — VRT Builder. In the new window that appears. Click on the Select source files: (Green folder before this text)
Guide the linux dialog windows to your franceDM folder (or what ever name you gave this folder)

My tiles

Select all the files from this window and click open. You’ll have a new window like this

Next step TARGET Filename
Build the VRT

So with all your tiles now in the left hand window, all you need to do is click on the Target Filename: (Blue folder before this text)
This will open a window so that you can create (or modify an existant xxx.vrt file) In you case of a new one so just give this file a name. In my case FranceDEM.vrt I saved this file next to my franceDM folder but I believe you can put it almost any where.

Now back to the small window that you should have showing, probably empty when you created the window from the top tool bar : Window – – Dig. Elev. Model (DEM)

My DEM window is on the left

In this empty window, right click and use the Setup DEM Paths

Now as you can see , you just have to add the path where the DEM files / folders are

All being well this will now add to this empty window FranceDEM (this is the FranceDEM.vrt file. Now right click to activate it

Going back to your trace that you have been working on and lost the elevation date, Right click on the trace , choose Replace Elevation by DEM.

Now your Track Information windows should now show you the data like before you started playing with the trace and lost it.

It’s done, you can now modify your trace, add, remove, change it. The elevation data will still be shown thanks to DEM data for QMapShack

Easy non ????

Leave a Reply

Your email address will not be published. Required fields are marked *